Jump to content

Installing new fixtures on outside of home


Recommended Posts

My wife recently purchased some new lights to mount on the outside of our home on either side of the front entry door. When I removed the old fixture and the mounting bracket I found that the mounting bracket was just screwed into the old siding, and not connected to an electrical junction box.

It appears that whoever installed the previous fixtures just drilled a hole in the old siding and ran the wire through. I have spoken with a few a my neighbors who have encountered a similar situation.

Granted my house was built in 1968, but if I remember the code correctly any electrical junction had to take place in a electrical box.

Currently my house has a layer of vinyl siding, followed by a later of insulation, and then a layer of old wood siding, after that I am not sure if there is plywood or, if the old wood siding is just nailed into the framing.

I am trying to find the best way to install the two electrial junction boxes for these fixtures. Should the new boxes be mounted flush with the old wood siding, or if there is plywood behind it is that where the box would need to go, any help with this would be greatly appreciated.

Thanks

Scott G.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...