Jump to content

Plastic Sqaure D panel


Recommended Posts

Hello all,

I ran into this Square D electrical panel today. The door and dead panel are made of brittle plastic. I could not get the plastic screws into the correct position to remove the panel to expose the wiring. The breakers as viewed from the front were new to me and the whole set up looked as though it were a complete unit.

I am wondering if any of you out there have had experience with this type of panel and are there any considerations I might pass on. (There are other electrical isssues with the home and I have recommended that an licensed electrician take a look at the home)

Thanks, all your input is appreciated.

Eric

Download Attachment: icon_photo.gif SQd-breakers.jpg

15.92 KB

Download Attachment: icon_photo.gif SQd-instructions.jpg

33.06 KB

Download Attachment: icon_photo.gif SQd-panelcover.jpg

10.31 KB

Link to post
Share on other sites

holmer,

I had this panel last week. Tough time getting the cover off (had to line up arrows on screws and pull hard); tougher time getting the cover back on. Finally had to line up pins (got them into hole) and pounded on each corner. After that, adjusted arrows so it was tight. All in all, I'd say about 10 minutes taking cover off, 15 minutes getting it back on. Next time should be quicker.

Darren

About the House (new name)

Succasunna NJ

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...