Hi: I"m just a homeowner hoping to install a hot tub in the best location for my small backyard. The City gave me a Building Permit today with my desired hot tub placement, but also a big note saying I needed to comply with NEC 680. I've attached a picture showing my backyard plan with my desired hot tub placement (the plan that the City approved today). I"ve downloaded Mike Holt's great Article 680 for swimming pools, but I'm not sure that I thoroughly understand the overhead conductor clearances -- or maybe it's wishful thinking because of my desired placement of my proposed hot tub My electrical conductor lines are more than 22.5 feet above the highest level of the hot tub. The location of where the conductor line comes into the house is more than 22.5feet from the edge of proposed hot tub.' HOWEVER, the overhead lines are HORIZONTALLY less than, say, 2 feet from the edge of the hot tub. (So, to make a picture... you could stand 2 feet from edge of proposed hot tub and look up and the conductor wires are 22.5+ feet right above your head. I"m hoping for an interpretation that says if the wires are 22.5 feet above you, then all is well, BUT if they are NOT 22.5 feet above you, THEN you need 10 foot horizontal clearance. Please, please...I hope. If I have to move the hot tub over 9 feet,(to keep 10 ft horizontal from overhead conductors) it will sit in the middle of my (very small) yard, and just not function effectively for our family needs. If I can leave the hot tub over near the fence (the overhead conductor wires run diagonally from fence line at rear of lot to roof of house with 3' setback), then placement is great. Is there any support for my interpretation or is it 10'horizontal AND 22.5 in any direction? and I'm @#$%ed??? Any thoughts, suggestions would be much appreciated. Marilyn Download Attachment: approved plan partial.jpg 291.16 KB